This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

NNM9i - custom poller - specific bgppeerstate

Hi,
I want to be able to check every 15 minutes on the bgppeerstate of an connection ipaddr 10.10.10.3 and if the state is not 6 generate an Incident. I do not want to check all nodes in a node group and all instances on them if possible.

This was a simple task in nnm7 with data collection - but I am just not getting to grips with it in nnm9.

Can someone give me an helping hand?

regards,
Siggi
Parents
  • 0
    Hi Nick,
    the thing is that I have several connections but only one is critical for me. That is why I dont want to enable snmp traps for bgp, there is a lot of noise from this box.
    The way I do this in NNM7, is by data collection (polling every 15 min) the specific item( .1.3.6.1.2.1.15.3.1.2.(ipaddress) ) and if the status is not equal to 6 then event.

    With the custom poller I can get to select bgppeerstate but not the specific item(but this is probably due to lack of knowledge of the new NNM9 system :-) ).

    regards,
    Siggi
Reply
  • 0
    Hi Nick,
    the thing is that I have several connections but only one is critical for me. That is why I dont want to enable snmp traps for bgp, there is a lot of noise from this box.
    The way I do this in NNM7, is by data collection (polling every 15 min) the specific item( .1.3.6.1.2.1.15.3.1.2.(ipaddress) ) and if the status is not equal to 6 then event.

    With the custom poller I can get to select bgppeerstate but not the specific item(but this is probably due to lack of knowledge of the new NNM9 system :-) ).

    regards,
    Siggi
Children
No Data