This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

GroupWise 2012 client build from template -- Attachment control component error

MigrationDeletedUser over 11 years ago

I built the GW 2012 client (not SP1) using the GW template from ZAV
901. When I run it I get and error box containing the message
"GroupWise is not properly installed. The Attachment control component
could not be initialized."

When I hit OK to this I get "Attachment control interface version does
not match!"

This is built on an XP SP3 VM on ESX5. It's a clean base with nothing
installed but ZAV.

Any ideas?

Thanks,

Don

0 MigrationDeletedUser over 11 years ago

Don,

I'd like to test this in-house to see if I get the same results. Just so I know: are you testing the virtual application on the same machine that built it? Are you just running the exe, or have you used Spoonreg to register it to the machine you're testing with?
Cancel
Vote Up 0 Vote Down

Cancel
0 hko over 11 years ago

Hello Don, whe have exactly the same error with ZAV 10, and GW2012SP1 template. Did you have already a solution for this? And i was wondering is there a 'ZAV Store' where whe can upload our builded ZAV Application to share this with other ZAV users?
regards, HKO
Cancel
Vote Up 0 Vote Down

Cancel
0 MigrationDeletedUser over 11 years ago in reply to hko

I can't speak to the solution here, but I can answer the question regarding a "ZAV store". This is actually mentioned in one of the sticky threads, but here is a site:

https://www.novell.com/communities/coolsolutions/virtual_applications

You can follow the instructions to share an application. It's a bit old (options only go to ZAV 8), but it's as close as I have found to what you are looking for.
Cancel
Vote Up 0 Vote Down

Cancel

Menu

Hybrid Workspaces Discussions

Verified Answers

GroupWise 2012 client build from template -- Attachment control component error

Resources