ZENworks Endpoint Security Management Discussions

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ZENworks 11.4.2 logging

MigrationDeletedUser over 8 years ago

Not sure if this is the right place for this question, but here it goes. I am seeing a lot of generic errors within the ZENworks Control Center for different bundles, but they don't have much information on them. I know there is a lot more information within the local logs that I cannot access, due to user is busy or access restrictions. Is there a way to have the ZENworks Agent write the logs to a different location rather than locally? Perhaps to a shared folder on a network drive? I'm not sure if there is a config file that tells it where to write the logs to but it would be very helpful if all the device logs were in a centralized location rather than only saved on the workstation.

0 MigrationDeletedUser over 8 years ago

schiess,

It appears that in the past few days you have not received a response to your
posting. That concerns us, and has triggered this automated reply.

These forums are peer-to-peer, best effort, volunteer run and that if your issue
is urgent or not getting a response, you might try one of the following options:

- Visit https://www.microfocus.com/support-and-services and search the knowledgebase and/or check
all the other self support options and support programs available.
- Open a service request: https://www.microfocus.com/support
- You could also try posting your message again. Make sure it is posted in the
correct newsgroup. (http://forums.microfocus.com)
- You might consider hiring a local partner to assist you.
https://www.partnernetprogram.com/partnerfinder/find.html

Be sure to read the forum FAQ about what to expect in the way of responses:
http://forums.microfocus.com/faq.php

Sometimes this automatic posting will alert someone that can respond.

If this is a reply to a duplicate posting or otherwise posted in error, please
ignore and accept our apologies and rest assured we will issue a stern reprimand
to our posting bot.

Good luck!

Your Micro Focus Forums Team
http://forums.microfocus.com
Cancel
Vote Up 0 Vote Down

Cancel
0 strj500 over 7 years ago in reply to MigrationDeletedUser

I don't there's a file to automatically configure (welcome corrections if I'm wrong). You can specify the location by zac zeninfo <new_location>, for example zac zeninfo -C:\, you could likely make a bat file do that for you.
Cancel
Vote Up 0 Vote Down

Cancel

Menu

ZENworks Endpoint Security Management Discussions

Verified Answers

ZENworks 11.4.2 logging

Resources