We have project which involves sending text to customer display pole, has anyone out there worked with this type of device? If so, I sure could use that source code/
Cybersecurity
DevOps Cloud
IT Operations Cloud
If an answer to your question is correct, click on "Verify Answer" under the "More" button. The answer will now appear with a checkmark. Please be sure to always mark answers that resolve your issue as verified. Your fellow Community members will appreciate it!  Learn more
We have project which involves sending text to customer display pole, has anyone out there worked with this type of device? If so, I sure could use that source code/
There are many different brands. What do you have? If needs be can you change?
If you are familiar with ActiveX, perhaps use an OPOS compliant brand like Mecer
If you are familiar with serial coms, perhaps use a serial brand with AcuCobols ACURS32.DLL
The easiest may be to use some freeware like DOSPrint (or SAMBA) and setup a pseudo printer on the USB port.
There are many different brands. What do you have? If needs be can you change?
If you are familiar with ActiveX, perhaps use an OPOS compliant brand like Mecer
If you are familiar with serial coms, perhaps use a serial brand with AcuCobols ACURS32.DLL
The easiest may be to use some freeware like DOSPrint (or SAMBA) and setup a pseudo printer on the USB port.
Thank you Peter I will check up on the ACURS32.DLL, and the unit we ordered is Logic control LV5000
Logic Controls LV5000 LCD Customer/Pole Display: Barcode Giant
I am still waiting for it to be delivered.
Peter, I check with Micro focus and the ACURS32.dll is not a .dll supported by them, any idea who has this .dll?
I have - and still use - the dll. However, if you can use DOSPrint to assign a printer to the USB port and then simply "print" to that printer, it will be much easier. Also a better option given that MF no longer support ACURS32.
Try that first, else I can let you have my program (written about 20 years ago ). DOSPrint can be download on the internet.
You would only need ACURS232 for bi-directional communication; not for printing.
Its a long time since I used serial printers but my recollection is that you open and write to a FileName where you have an entry in the configuration files FileName -D COM1.
You would also need to set the port parameters using (dos/cmd) MODE COM1: 96,N,8,1,P (Baud, Parity, Bits, Stop Bits, I think P means hold parameters)
Let me know about ACURS232. Program is free, but if you need my time, lets talk
Thank you for your reply, Peter. Yes, this will be used to connect to a serial customer display pole. I wrote a small program and assigned the printer to "_D COM1" and was able to open the printer and send data to it, unfortunately, it sent an unreadable text to it. I might need to download the drivers for this display pole and try again later this week. If you can send me the ACURS232 and any documentation that would be great.
Again; many thanks
Alex Albergo
You did use the MODE command to set the correct RS232 communication parameters? "Printing" is the easiest and I am sure your problem is baud rates etc. Alternatively, Is the display OPOS compliant (so you can use the OPOS.OCX) . Try this. Select START, RUN, CMD. | type MODE COM1:96,n,8,1,p. | type dir > com1 | If the characters are gibberish check what baud rate etc the display is set up for.
I tried the above from a DOS prompt and nothing happened. iT SAID SYSTEM CANNOT FIND THE FILE WHEN I TYOE DIR > com1